Products

Back
Autofresh

Rapid Renovator Plus

A heavy cutting machine polishing compound ideal for quickly removing deep paintwork imperfections

  • 1  2  3  4  5 

Features
  • Diminishing abrasives for perfect combination of cut and finish
  • Minimal product fling
  • High level of cut
Customer benefits
  • One compound can be used to start and finish a renovation
  • Little to no clean up after use
  • Renovates quickly and safely
Videos
Usage instructions
1.0
step 1

Thoroughly clean and dry the vehicle, ensuring any industrial fallout and contamination is removed from the paintwork. Remove any tar and previous polishes and coatings from the surface using Autoglym Tar & Adhesive Remover.

2.0
step 2

Mask any swage lines, badges, delicate trim and difficult to reach areas with tape or film.

3.0
step 3

Using a medium foam pad (we recommend the white Autoglym Renovate Pad), apply three dots of Rapid Renovator Plus, each about the size of a pea, directly to the pad. More product will be required for a fresh pad.

4.0
step 4

Working on a section at a time, apply the pad to the top of the panel then start the machine at a low speed (600 - 800 RPM). Pass over the area in a horizontal motion, gradually increasing the speed to 1500 - 1800 RPM. Add more product as needed and continue until the desired result is achieved.

Expert Tip: If the finish requires further refinement, use Rapid Renovator to complete the task.
  • Rapid Renovator

    A machine polishing compound that quickly removes paintwork imperfections and leaves an ultra-gloss finish.

Download safety data
Download the PDF